THERMAX™ HTS high-temp support 3D printing filament

Code: 3659

Not rated

Tisková struna THERMAX™ HTS high-temp support

€182,54 €150,86 excl. VAT

Delivery to: 04/05/2024

ThermaX™ HTS [High Temperature Support] break away support is ideal for printing high-temperature polymers including PSU, PES, PPSU, PPS, Ultem™ PEI, PEKK, and PEEK. This support adheres well to these advanced materials and then is broken away after printing to allow for complex geometry without damaging your part.

Detailed information

Show all related products

Product detailed description

Thermax™ HTS High-Temp Support Filament

Our break away high-temp support filament is ideal for use in dual extruder 3D printers designed to print high-temp materials.

HTS is the premium support for our high-temp products, unlike most support filaments, which are not designed to withstand the heat required to print the top-end of performance materials.

Works ideal with the following ThermaX™ materials:

Support Removal:

This is break-away support and does not dissolve.
High-Temp support is best removed while printed part is still warm.
If the finished printed part cools completely and the support removal gets too difficult, you can re-warm the part in the printer chamber or an oven not exceeding the Tg of the model material you are printing with.

Filament Specifications:

1.75mm and 2.85mm +/- 0.05mm in diameter

Recommended Print Settings:

Extruder: 350-380°C
Bed Temp: 120-160°C
Bed Prep: Nano Polymer Adhesive or Polyimide Tape gives us the best results.
Heated Chamber: All high-temp materials print better with a heated enclosure or build environment. Enclosure temp should not exceed 185°C for our high-temp support material to remain structurally sound as a support.
Other: Don’t use a cooling fan while printing this support.
Drying Instructions: 120°C for 4 hours

ULTEM™ is a registered trademark of Sabic Innovative Plastics.

Additional parameters

Category:	Support filaments
Warranty:	24 Měsíc(ů)
Weight:	0.95 kg
Material:	THERMAX
Výrobce:	3DXTech
Průměr struny:	Ø 1,75 mm +/- 0.05 mm
Hmotnost návinu:	0.5 kg
Země původu:	USA
Doporučená teplota extruze:	350 - 380°C (all-metal extruder)
Doporučená teplota podložky:	120-160°C
Doporučená teplota komory:	max. do 185°C